Error deploying report from dev to test using deployment pipelines.

[LuisVasquez]

HI everybody, I'm facing this error when try to deploy my report to test workspace using a deployment pipeline

And if I try to deploy the semantic model asociated to the report separately I receive this error

The dataflow used for this report exist and work in the Test workspace.

The report basically consists of 6 pages of common visuals, 1 map, and 1 line chart with forecast functionality enabled.

Another report exists in the development workspace and is successfully deployed through the pipeline.

[Anonymous]

Hi @LuisVasquez ,
Based on the error screenshot and information you provided, you can troubleshoot whether this is the cause of this error from the following aspects. 
First make sure you have the necessary permissions for the development and test workspaces and the deployment pipeline. At a minimum, you need to have contributor access to the workspace and permission to use the pipeline. Second, if your reports depend on data sources that require a data gateway, make sure that the gateway is properly configured in your test environment. Data source rules and parameter rules should be properly managed between environments. Finally, since another report was successfully deployed, compare the configuration between the two reports. To find differences in data sources, parameters, or features (such as predictions that may not be supported by the test environment)
For more information on planning the deployment of pipeline access permissions you can refer to this official document
Power BI usage scenarios: Enterprise content publishing - Power BI | Microsoft Learn

Best regards,

Albert He

If this post helps, then please consider Accept it as the solution to help the other members find it more quickly

[LuisVasquez]

Hi @Anonymous  Thanks for the response, in fact I have all the necessary permissions in Power BI Service, I also just checked the possible differences between both datasets/dataflow and I don't see any, I just deleted and created the dataflow again and I still can't promote it to Test and show the same error. I had read somewhere that the metadata had to be reviewed to locate and correct differences, but I don't know where to look for the metadata and where to modify it.

I'm still investigating, if you can think of any other possible solution I'm all ears.