Adding destination lakehouse to Dataflow Gen2 does not work

[Fave24]

Hi,

I am trying to connect a lakehouse to my Dataflow Gen2. However, when clicking "Add data destination" the "Create new connection" dropdown keeps on updating/refreshing, like in the screenshot below.

I already tried switching from the Data Factory experience to Data Engineering experience and vice versa. Also I tried building a new Dataflow in a new Workspace, but did not work out as well.

Does anyone have a solution for this?

[HimanshuS-msft]

Hello @Fave24 , 
I am unable to repro this on my side , I did tried in Chrome and Edge .

In case if you are having a consistent repro ( which looks like you do ) , please reach out to the Microsoft Support and they can work with you to resolve this . 
Thanks 
Himanshu 

[govindarajan_d · Accepted solution]

This does occur once in a while and I have faced the same issue. I had to wait for an hour or two and then try again and it would work without issue.

[PhilE]

Do we know the reason for this?  I am having the same issue.

When I add one table destination to my lakehouse, it takes a while to be able to do the next.

Does it have something to do with refreshing OneLake?  OR refreshing something?

Thanks,

Phil

[TravJ]

Exact same issue here. After much frustration a restart of my laptop worked for me... 

[RandyEliason]

I get this issue and I have waited more than 24 hours for it to resolve.  Is there any other work around for this?

[RandyEliason]

I let it run for 36+ hours over the weekend, and it resolved itself.  

[Fave24]

Thank you for responding!

It works again, but in my case it took about 24 hour ☹️

Good to know this might happen.