Want the 'what if' parameter selection hard coded dynamically for each column of my calculated table

[klehar]

Hi all,

I want my 'what if' parameter selection hard coded dynamically for each column of my calculated table.

For Eg see below

Requirement 1

I have amount column in my table and I want that whatever value i select on my what if parameter, it goes and sits in each row of the percent column.

Requirement 2

This table below should be a new DAX table that uses addcolumns or selectedcolumns calculation.

Amount	Percent
10	30%
20	30%
30	30%
40	30%
50	30%

After this I want to perform some calculations using amount and percent but this would happen only when I acheive the above.

[amitchandak]

@klehar , You can not use what if column calculation. Actually, you can not use slicer in a calculated column calculation

You can use it only in measure 

For static value

new column  = .3 //mark as 5 column it will be 30 %

[klehar]

@amitchandak I know I cant use measures in calculated columns. 

But i'm looking for workarounds