Refresh Getting failed

[Nadeem_Ahmed]

Hi,

When refreshing a report, I am getting following error.

The last refresh attempt failed because of an internal service error. This is usually a transient issue. If you try again later and still see this message, contact support.

[rajendraongole1 · Accepted solution]

Hi @Nadeem_Ahmed - Check all data source connections are valid and accessible. Verify that any credentials used for data connections are up to date. If you are using an on-premises data gateway, ensure it is running and properly configured. Restart the gateway if necessary.

If needed you can log a support ticket toohttps://powerbi.microsoft.com/en-us/support/

Solved Reference Link:

Solved: Refresh failed : internal service error - Microsoft Fabric Community

Hope it helps

[Anonymous]

Hi @Nadeem_Ahmed ,

Did @anmolmalviya05  @rajendraongole1 reply solve your problem? If so, please mark it as the correct solution, and point out if the problem persists.

Best Regards,
Adamk Kong

[anmolmalviya05 · Accepted solution]

Hi @Nadeem_Ahmed, Hope you are doing good!

Please checkout the below solution : https://community.fabric.microsoft.com/t5/Service/Refresh-Failed-Internal-Service-Error/m-p/381780

[rajendraongole1 · Accepted solution]

Hi @Nadeem_Ahmed - Check all data source connections are valid and accessible. Verify that any credentials used for data connections are up to date. If you are using an on-premises data gateway, ensure it is running and properly configured. Restart the gateway if necessary.

If needed you can log a support ticket toohttps://powerbi.microsoft.com/en-us/support/

Solved Reference Link:

Solved: Refresh failed : internal service error - Microsoft Fabric Community

Hope it helps