Display issue PowerBI

[puj831]

Hello all,

I am currently using ArcGIS Maps on PowerBI, however not all the coordinates show up. I have close to 250,000 lat/long coordinates where I would like for them to show up on the U.S. Map (all at once).  However, it just covers half the map.

Are there any suggestions to get around this? Thanks.

[RMDNA · Accepted solution]

Hi @puj831,

I believe there may be a limit to the number of data points that can be rendered at any given time - 250K is a lot for a map.

Will the data always be viewed in full, or is there any way to keep it filtered by default?

[puj831]

Once it gets filtered, then the lat/long improves quite a lot. Its just when it takes in all the raw data.