Report in service dont show data

[Peter_23]

Hi community, I publish a report with data source from web -> anonymous connection, in desktop the dat show. Ok. but I had to published in the service but dont data, only blanks values! 😞

Any configuration to modified?

and another question: if the source (web page) update, the data's report update too?

thanks in advance.   

[Akash_Varuna]

Hi @Peter_23  The issue might be because the web data source is using anonymous authentication, which isn't properly configured in Power BI Service. Check Data Source Credentials in the Service and ensure it's set to Anonymous (or the correct method).

[Peter_23]

Thanks @Akash_Varuna  the data sources it's gray

[sergej_og]

Did you set up the connection in your gateway to be able to access data?

[Peter_23]

thanks @sergej_og  is this required a gateway from source web page?  I didn't find in this guide.  https://learn.microsoft.com/en-us/power-bi/connect-data/desktop-connect-to-web

[sergej_og · Accepted solution]

If I got you right, you need a sematic model in Service which can be refreshed on scedule.
Therefore you need to set up a connection to your source.
Like this:

Select the proper Auth-Method and save it. If everything went well you will see on the top of this window a message about a succefully created conncetion.
You can use this connection (dropdown) in the Gateway section of your model to refresh your model on schedule.
Hope that helps you.