Show only Total serie on a line chart with legend when there is no slicer selection

[Taurus]

Suppose we have some "Category" field in a slicer, and this field is placed in the line chart legend.

Is there a way to show only one serie (for example, serie of total aggregation) when there is no slicer selection, but otherwise the line chart legend acts as usual (shows multiple series according to slicer selection)

Thanks.

[antona]

Any luck ?

I have similar request , when non of filter selected then line chart show with single line with sum of total whereas when we select filter with multiple select then it should multiple lines. 

[Taurus]

I meant that if nothing is selected in the slicer, then as if there is no line chart legend at all

[v-piga-msft · Accepted solution]

Hi @Taurus ,

I 'm afraid that we cannot achieve that in Power BI currently. 

As the legend cannot be a measure so it cannot be dynamically.

Best Regards,

Cherry

[v-piga-msft]

Hi @Taurus ,

I have a little confused about your requirement.

Normally, if you don't select the options in the slicer, the line chart will show all of the legend like below.

If we select one or more options in the slicer, it will show the filtered legend in the line chart.

If you still need help, please share your desired output so that we could help further on it.

Best  Regards,

Cherry