Field Parameter in matrix visual- Change of Sequence

[dsl98]

Hi all, I was trying to change the sequence of the columns shown in matrix table.

As per screenshot below, it is currently shown as countries (normal fixed columns - ID, MY etc.), then the values of field parameters based on drop down (eg. NTS PY, NTS LT...)

However, in the columns, I would prefer to show the field parameter values first, then the markets (eg. NTS PY, then ID MY PH..; then NTS LT, then ID MY PH..). Hope to achieve the visual preference so that I can see each field parameter category at one glance. Thanks! 

[Uzi2019]

Hi @dsl98 
Try to put your filed parameter category in column then  your country in column of matrix visual.

I hope by this way you get the desired result.

[dsl98]

Thank you for your reply. I tried but it did not work. If I remove the Values and keep the 2 columns, it will be blank.

I also drilled up and down using different order of sequence, but it did not work too.