Forum Discussion
Data lines with 0 values displayed anomalies when selected using a slicer
I am using the line chart to display a trend of defects by dept. Some depts has 0 defects but still required to be displayed in the chart.
To do this, I added each dept defects count into the Y-axis.
However, when selected a dept that has 0 value, 2 anomalies occurred:
1. Instead of displaying the selected dept, it shows the first dept. The correct dept is shown is selected a dept with values.
2. The 0 on the line appeared more then 1 as shown in the picture.
Are there alternate settings to resolve the above issues?
Thank you in advance!
4 Replies
- sturlaws
Resident Rockstar
Hi, Anonymous,
have you created a measure, or are you using an implicit measure? Do you have a date-table?
I am not able to recreate your issue, but you could try to write a measure like this:Measure = SUMX('Table',if(ISBLANK('Table'[value]),0,'Table'[value]))Cheers,
Sturla
If this post helps, then please consider Accepting it as the solution. Kudos are nice too.Hi sturlaws ,
I am getting the data from a table like the following:
The following columns are selected for the Y-axis:
Cheers!
- sturlaws
How have you created your slicer?
Anyway, the your table is not optimal for what you are trying to do. I would place department on rows instead, like this:
