Switch not showing correct result

[TomaKavi]

Hello guys, 

I have a problem and I am desperate. The below DAX is not showing proper result. If i hard code it and replace [SR1100 Total test] with lets say ,,10000,, it works, shows 10000 in the specific row and other figures are measured properly as [Total Value]. But If I leave the [SR1100 Total test] it will show 0 (its becasue the  [Total Value] was defined to show 0 if its blank.

This measure is simple [SR1100 Total test]  =

CALCULATE (

[Total Value],

Total_2021[Consolidation account]

IN {

"V10000",

"V20000",

"V30000"

}

)

Switch Values =

VAR CurrentItem = SELECTEDVALUE( Conso_Temp[Description - Normalized] )

RETURN

SWITCH( TRUE(),

CurrentItem = "Operating profit or loss (+/-)", [SR1100 Total test],

CALCULATE( [Total Value], FILTER( Conso_Temp,Conso_Temp[Description - Normalized] = CurrentItem )))

as you can see it shows 0 but should be (lets say 143900) the Value above is correct.

Table where I show these result is connected to Fact Table where the ,,Total Value,, are counted. I also need to filter it via country a loop up table which has direct connection to Fact table. I use the SWITCH in a Table vizual which is take from Conso Temp. 

 Any ideas why I cant see what I need? 

[Anonymous · Accepted solution]

Hi @TomaKavi 

I am so glad to hear that your problem has been solved , please consider Accept it as the solution to help the other members find it more quickly. 

Best Regards,
Community Support Team _ Ailsa Tao
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.

[TomaKavi]

actually I have added into the
SR1100=

CALCULATE (

[Total Value],

Allselected (),All() Total_2021[Consolidation account]........ works now

[johnt75]

Try changing the measure to

[SR1100 Total test]  =
CALCULATE (
[Total Value],
Total_2021[Consolidation account]
IN {
"V10000",
"V20000",
"V30000"
},
REMOVEFILTERS(Conso_Temp[Description - Normalized])
)