Blank value after filter condition

[CalvinBB01]

here i have below issue:

when there's no data with the filter, the value will be Blank.

If I change it to " if(isblank(Value), 0, Value)", then it will present 0 which is fine.
but when I create a daily chart with the value, there's lots of 0 showing from the chart which is not my purpose.

is there any good solution? many thanks!

[ChandrashekaraD]

Open Power Bi Desktop  and go to Visualiztion Tab, you can see the Card Visual Screen shot is Attached ,

If you are not able to Locate ?

then click on the  three Dots you can see on the Visualiztion Tab Last and click on get more Visuals you can type card in the Search box and you can add to you power Bi desktop 

[ania_roh]

Hello,

If you change the measure like that, the chart will always show zeros. 

You have two solutions:
- put filter in the panel filter with the measure is not 0 :

- or create two different measures: one for the chart (leaving it as blank) and another for a card

Also, I recommend you use :
[Value] + 0
istead of:
 if(isblank([Value]), 0, [Value]

It is the same thing but it is more efficient. 

[ChiragGarg2512 · Accepted solution]

Use Card(new) visual    in that in callout value section there is an option on what to display when the vaue is blank.

[CalvinBB01]

Thanks, Where can i find the new Visual Card?

[ChiragGarg2512]

@CalvinBB01 If you still haven't found it.