Slicer is not showing any value when i am using Format option for different slicer sync.

[sagarsahoo_123]

Hi All,

Need your support to resolve on the slicer sync issue. I have created a page in which different slicers are used. I have partitioned the page into two and in each side using same slicer but with no relation or not synced with other side. Upto this it is working fine with Format with Edit interaction option. But i bring three new slicers which are common in both sides, but it is showing nothing when selected. Here is attached image below.

If you look at the relation for the "Personal_Subarea" slicer , when selected nothing is showing. Same with other two slicers placed right to it. How to resolve this, so that value can be shown for this three slicers.

Any help would be highly appreciated.

Regards,

Sagar

[sagarsahoo_123]

@Uzi2019 ,

Thanks a lot for a quick support. Yes you are right. Both slides slicers condition were not allowing to show anything for different selection at a time.

Regards,

Sagar

[Uzi2019 · Accepted solution]

Hi @sagarsahoo_123 

you are facing this issue beacuse all 7 slicer on top are filtering your "Personal_Subarea". these 3 slicer billable and ILP catrgory and sub brand have 2 different values which causeing a problem for "Personal_Subarea". > and < are applying for same time and such values are not exist in "Personal_Subarea".

solution:
Use edit iteraction from billable , ILP catgroy and sub brand to "Personal_Subarea"  as "None".

like you did for other section.

either of your side will filter the "Personal_Subarea". simultenoulsy both side are filtering your "Personal_Subarea" so avoid it. 

 try to remove edit interaction from one sde. it auto solves your problem.

I hope I answered your question!