Slicer Not Showing Two Input Boxes

[ahlee]

Hello,

I have a date slicer in Power BI that allows for two input (start and end date, essentially).  However, for some reason, the second date selection box sometimes doesn't show up (and then sometimes it does?).  What is the fix for this problem / what's driving this issue?

What it's suppose to look like:

What it's showing currently:

[Anonymous]

Hi @ahlee ,

I can't reproduce your problem, the version of my Power BI Desktop is 2.109.1021.0 64-bit (September 2022) . What's the version of your Power BI Desktop? By the way, the data type of the field which apply on the slicer is Date type? And are you creating the slicer with Between option? Thank you.

Power BI Desktop Version

Slicer with Between option

Best Regards

[ahlee]

I'm using Version 2.110.805.0 64-bit (October 2022).  I inherited this file but I believe it was created with an older version.  The data type is "Date" and you have the correct visual -- the slider on the bottom has just been turned off.  And yes, the between option has been selected.

[Anonymous]

Hi @ahlee ,

The problem still can't be reproduced in my side when I just use the same version as yours. Could you please share your pbix file with only the table data with that date field(exclude any other sensitive data in your pbix file)? Later I will make troubleshooting and check if your pbix file can work in my side to find the cause and get the solution. Thank you.

Best Regards