Forum Discussion
Quick Question About Filtering Upon Selection Capability in Power BI (Single Chart or Same chart)
I was wondering if there's a capability or a workaround in Power BI in which for example if I have a bar chart so that when I click on a bar for instance, it filters the chart to show only that bar's value, instead of just highlighting it?
I'm not talking about cross-filtering or cross-highlighting. I'm talking about a single chart here or even if we have multiple charts, I'm talking about the current chart that I'm selecting on.
Thanks in advnace!
Hi ahmedalbabili95 ,
Below is my table:
workround1:
You click the show data point as a table , and you will see the only bar value in the report.
workround2:
you can open the data label , and When you click on the column chart, the values inside will also be highlighted
The final output is shown in the following figure:
Best Regards,
Xianda Tang
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.
1 Reply
Hi ahmedalbabili95 ,
Below is my table:
workround1:
You click the show data point as a table , and you will see the only bar value in the report.
workround2:
you can open the data label , and When you click on the column chart, the values inside will also be highlighted
The final output is shown in the following figure:
Best Regards,
Xianda Tang
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.