Forum Discussion

4 Replies

  • Anonymous's avatar
    Anonymous
    Not applicable
    4 years ago

    Good you raise that question 🙂
    As you can see the position of the values is not correct (large value lower than lower value for some periods). 
    Setting position is "Auto"

    ,

     

    • v-kkf-msft's avatar
      v-kkf-msft
      Community Support
      4 years ago

      Hi Anonymous ,

       

      Please set the position of Value 1 and Value 2 as one "Under" and one "Above".

       

                         

       

      If the problem is still not resolved, please provide detailed error information or the expected result you expect. Let me know immediately, looking forward to your reply.
      Best Regards,
      Winniz
      If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.

       

      • Anonymous's avatar
        Anonymous
        Not applicable
        4 years ago

        Tnx for reply, 

        Here you assume that the value line 2 is alway higher than value line 1.  If the lines are close and cross eachother than above/below setup would look strange/wrong.