Forum Discussion

karaoan's avatar
karaoan
Kudo Kingpin
9 years ago

Numeric Slicer doesn't accept zero?

I assume it's a bug that the preview of the numeric slicer doesn't accept zero (which is part of the underlying attribute used as the basis for the slicer) as an entry in any of the configuration set...
General Comment
Anonymous's avatar
Anonymous
Not applicable
9 years ago

Hi karaoan,

Could you please post a screenshot and share sample data of your scenario?

Based on my test, when my numeric column contains zero,  zero also appears in numeric slicer and I can use the slicer to filter visual, you can check the following screenshots of my scenario.



Thanks,
Lydia Zhang

karaoan's avatar
karaoan
Kudo Kingpin
9 years ago

Hi Lydia,

 

I am using a source with negative and positive values. When I enter "0" it displays "-1000". Interestingly, though the variable linked to the slicer selection carries the correct value:

 

underlying rangewhen entering 0-1000 is displayed

  • Anonymous's avatar
    Anonymous
    Not applicable
    9 years ago

    Hi karaoan,

    I can reproduce your issue, I will report this issue internally and post back once I get update.

    Thanks,
    Lydia Zhang