Forum Discussion
Dynamically Resize when using small multiples and slicers
Hi rseals,
Thanks for reaching out to the Microsoft fabric community forum.
Currently, Power BI’s small multiples layout is static in terms of the number of grid slots it reserves. It doesn’t automatically adjust the number of visible charts based on slicer selections. This is by design, as the layout is determined by the full set of values in the field used for small multiples, not just the filtered ones. As Greg_Deckler has already suggested you to share your feedback on Ideas Forum which would be open for the user community to upvote & comment on. This allows our product teams to effectively prioritize your request against our existing feature backlog and gives insight into the potential impact of implementing the suggested feature.
I would also take a moment to thank Greg_Deckler, for actively participating in the community forum and for the solutions you’ve been sharing in the community forum. Your contributions make a real difference.
If I misunderstand your needs or you still have problems on it, please feel free to let us know.
Best Regards,
Hammad.
Hi rseals,
As we haven’t heard back from you, so just following up to our previous message. I'd like to confirm if you've successfully resolved this issue or if you need further help.
If yes, you are welcome to share your workaround and mark it as a solution so that other users can benefit as well. If you find a reply particularly helpful to you, you can also mark it as a solution. And if you're still looking for guidance, feel free to give us an update, we’re here for you.
Best Regards,
Hammad.
Hi rseals,
Hope everything’s going smoothly on your end. As we haven’t heard back from you, so I wanted to check if the issue got sorted.
Still stuck? No worries just drop us a message and we can jump back in on the issue.Best Regards,
Hammad.
Hi rseals,
We noticed there hasn’t been any recent activity on this thread. If your issue is resolved, marking the correct reply as a solution would be a big help to other community members. If you still need support, just reply here and we’ll pick it up from where we left off.Best Regards,
Hammad.