Allow only two values selection in Slicer

[chotu27]

Hi Community,

Is there any way that i can limit only 2 values selection in Slicer. Like only two values are allowed to select from slicer if one select third value it should not allow

[v-alq-msft]

Hi, @chotu27 

It is unsupported to set default value and limit only two values selection in slicer. You may refer to the following ideas about the issue which have been submitted to Power BI team. You can vote the issue and add comments there to improve Power BI with the folloing links.

https://ideas.powerbi.com/forums/265200-power-bi-ideas/suggestions/7162004-default-selected-slicer-o...

https://ideas.powerbi.com/forums/265200-power-bi-ideas/suggestions/12299949-single-selection-slicer

Best Regards

Allan

If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.

[JarroVGIT · Accepted solution]

Hi @chotu27, as far as I know this is not possible using the standard slicer visuals. You might have some luck in the marketplace but I don't know about any that would fit this requirement, sorry.