Forum Discussion
Helper IAdding fields to "Show Data Point as Table" data & saving the resulting table
Hi, ElioAngarita
I reproduced your scene and found that it indeed can't be saved. I think it is by design and can't change.
I recommend you to use the drill through function, it can almost achieve the same effect.
Check it:
Set up drillthrough in Power BI reports - Power BI | Microsoft Docs
You need to put a table visual in the drillthrough page, and then add these fields to the visual.
'Drill through' will automatically drill to the data point of the data point you selected.
Did I answer your question ? Please mark my reply as solution. Thank you very much.
If not, please feel free to ask me.Best Regards
Janey Guo
Community SupportHi, ElioAngarita
I reproduced your scene and found that it indeed can't be saved. I think it is by design and can't change.
I recommend you to use the drill through function, it can almost achieve the same effect.
Check it:
Set up drillthrough in Power BI reports - Power BI | Microsoft Docs
You need to put a table visual in the drillthrough page, and then add these fields to the visual.
'Drill through' will automatically drill to the data point of the data point you selected.
Did I answer your question ? Please mark my reply as solution. Thank you very much.
If not, please feel free to ask me.
Best Regards
Janey Guo
Helper IYour suggestion was solved my issue and my requirement 100%! Thank you so much! Now with the drillthrough I'll be able to customize what i want to show and make it even more dynamic.
Thank you again,