Forum Discussion
could not load data for the visual
Anonymous Refer to this post here. Your problem might be related. As suggested by the user trying changing data type of column in data source. If you think it is not related then perhaps open a support ticket with MS support.
Hi jagostinhoCT,
I saw your another thread mentioned that the refresh is not working well.
http://community.powerbi.com/t5/Service/data-refresh-disabled/td-p/52899The error you mentioned here is usually a transient issue, which I think might be related with the Data Source connection. Please try it again and see what happens. If the issue insists, then we may take a network trace with the F12 tools to have a look first. Steps mentioned in the article below could be followed to perform the capture:
Network Capture - Edge & Internet Explorer
Once finished, please upload the saved file into OneDrive, then post the shared link in your next post, we will help to take a look.Regards,
Charlie Liao
Hey There!
I had a similar problem, but the error only occurs when I share my Dashboard with other users.
The error message displayed is:
Tente novamente mais tarde ou entre em contato com o suporte. Se você entrar em contato com o suporte, forneça esses detalhes.
In access with my user the dashboard works normally.
This is my Dashboard with the vision in my userAnd this is the dashboard in the view of the user receiving the share.
Best Reggards,
Thomaz
José_Thomaz did you finally solve your problem? I´m facing exactly the same ones with my report... it´s not affecting all my graphs, though just a couple of them.
Best regards,
Borja
Hi I have same problem. I created 2 pages with same template. One is fine, the other one is not working. can you please advise how to resolve this issue, thanks
