Forum Discussion
Solved
Updating issue
TomMartens Greg_Deckler bcdobbs AlexisOlson
I have a datset existing on service with incremental refresh for nearly all the tables.
I often find myself needing to
1. Add new tables from new so...
I tend to just connect direct to the dev model via xlma end point with tabular editor and add new tables there/configure new incremental when required. It's relatively straight forward in TE3 where you can right click to update table meta data once you've set it up. One done I use deployment pipeline to step through test and prod but you could connect straight to prod.
Would happily jump on a call and demo if you needed.
Hey smpa01 ,
you can do, this is exactly what ALM Toolkit was build for.
Of course you have to practice, a little.
Regards,
Tom
TomMartens AlexisOlson I am on Premium capacity, so it should not be an issue. I will give ALM toolkit and XMLA a spin and report back my experience on each