Forum Discussion
Slicer value not Holding
- Hi there
When you pin an item to a dashboard it remembers the filter when it was pinned to the dashboard.
When you click on a dashboard tile, it will remember the last state you had in your report and not the state of the dashboard tile.
The reason (I personally think) behind this is because the report keeps your last viewed state. And the dashboard keeps the state it was pinned as a tile.
So the reports and dashboards are mutually exclusive (meaning that they do not keep each others settings once they are pinned (Dashboard) or viewed (Reports)
Community SupportHi Anonymous ,
Yes,I agree with what is said by GilbertQ ,dashboard is just like a cover of your reports,what is shown on dashboard wont influence the actual reports,it is just a snapshoot of your reports,when you go to reports via dashboard,you will see the actual status of the reports.It may be same with what you see in dashboard,but may be different.All depend on the actual status of your reports.
Hope this make sense.
Kelly
Thank you GilbertQ & v-kelly-msft for the detailed explanation.
But I am wondering, if this is the behavior of Dashboard and Report how come it worked for me earlier? It used to work as I expected, with the most recent update I am seeing this kind of behavior.
Thanks,
Abhilash
- GilbertQ
Super User
Hi there
I have always seen the reports and dashboards behave in this manner. Not sure what has changed to be honest! - v-kelly-msft
Hi Anonymous ，
Yes,it has always been the behavior,I never see that the filter will pass through the dashboard.
Best Regards,
KellyDid I answer your question? Mark my post as a solution!