Something I've noticed with all my clients - scheduled refreshes of small datasets can take 10-15 minutes while a manual one takes seconds or a minute. Is there anything that can be done about it? I assume it has to do with queing?
Solved! Go to Solution.
Hi @zivhimmel ,
Does this issue have been resolved?We can also use Power Automate to execute an on-demand refresh.
Hi @zivhimmel ,
Based on my research, The reason scheduled refresh takes longer is because PBI smooths scheduled refresh so AS Engine and Gateway is not flooded with request. PBI doesn't do smoothing for on-demand refresh.
Such as if you set scheduled refresh at 9:00 am, it may start at 9:14 am, and end in 9:16 am, so seems it refresh 10 - 15 min, but if execute an on-demand refresh at 9:00 am, it will start right now and may end in only few minutes. This document also mentioned :
Note also that the configured refresh time might not be the exact time when Power BI starts the next scheduled process. Power BI starts scheduled refreshes on a best effort basis. The target is to initiate the refresh within 15 minutes of the scheduled time slot, but a delay of up to one hour can occur if the service can't allocate the required resources sooner.
If you needs the report be ready by certain time, schedule the refresh ahead of the time or execute on-demand refresh.
I am facing the same issue. I can refresh the power bi manually very fast (~5s), but schedule refreshing will consume more than 15mins.
I have tired to install 2 different gateways in 2 identical PC, but the result is still negative. Do you have any suggestion on this issue?
Thanks for your support.