Not all points are showing on map or heat map

[julietour]

Hi,

When I try to plot data on the map. It is not displaying all of the points. It said "28/40 displayed"

[gertjan2]

In Power BI there is a limit of the total amount of points. You see that in the editor in the upper right corner, the i. It says for instance 

"Too many values: Too many 'Content.Lat' values. Not displaying all data. Filter the data or choose another field".

Maybe you also run against this limit.

[v-piga-msft]

Hi @julietour,

Do you have this issue in other Maps like Bing maps or ArcGIS Map?

Have you tried it in Power BI Desktop? Did this issue also occur in Power BI Desktop, Check what category of your location?

If you still have the same issue in Power BI Desktop, you could change the data categeory to place in Power BI desktop then try again. If the map could load all locations in Power BI Desktop, then you publish it to Power BI Service to have a check if it is show as expected?

In addition, you could have a reference of this thread.

If you still need help, if it is convenient, please share some data sample which could reproduce this issue, so that I can have a test in my environment.

Best Regards,

Cherry

[julietour]

I dont have access to the desktop version since this is a work project.

I happens with bing map and the heat map.

Thanks,

Julie

[julietour]

Only some of my data is showing.

At the bottom of my map, it says 28/40 displayed... Any help?