Forum Discussion
Drill-through destination and source display
Hi, Developer_921
In Drill Through to Target Page, the point of your choice is applied to the target page. As shown in the image below, I select 2/1/24 drill through to page2, and the filter of 2/1/24 is automatically applied in the page2 drill through pane:
You'll need to place your source and target fields in the visual so that they can be displayed at the same time. In my example, I can show that point of my drill through in the target page:
You can refer to the sample PBIX file I provided below. If you're not familiar with Drill-through, you can learn more about it by clicking on the link below:
Use cross-report drillthrough in Power BI Desktop - Power BI | Microsoft Learn
Create a drillthrough button in Power BI - Power BI | Microsoft Learn
Power BI – How to add Drill Through to Reports - Xelplus - Leila Gharani
Best Regards
Jianpeng Li
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.
Hi, Developer_921
In Drill Through to Target Page, the point of your choice is applied to the target page. As shown in the image below, I select 2/1/24 drill through to page2, and the filter of 2/1/24 is automatically applied in the page2 drill through pane:
You'll need to place your source and target fields in the visual so that they can be displayed at the same time. In my example, I can show that point of my drill through in the target page:
You can refer to the sample PBIX file I provided below. If you're not familiar with Drill-through, you can learn more about it by clicking on the link below:
Use cross-report drillthrough in Power BI Desktop - Power BI | Microsoft Learn
Create a drillthrough button in Power BI - Power BI | Microsoft Learn
Power BI – How to add Drill Through to Reports - Xelplus - Leila Gharani
Best Regards
Jianpeng Li
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.
Thank you very much.
I understood that the visuals need to be placed at the drill-through point in order to be displayed at the same time.