Discrepancies between Reportloadtimes and ReportViews in Usagemetrics

[BI-Nomad]

Hi,

I wanted to ask if someone is aware and can provide a reasoning for the differences between the views =Countrows over the table  over the following two tables in the Report Usage Metrics Data model "ReportLoadTimes" and "ReportViews". These differences are really strange because some reports have big differences while others dont.

Is there a way to mitigate these differences? We have situations where the user looked at the Report 5 Times and this shows up when i look ath the Table "REport Views" but it doesnt show up under "ReportLoadtimes".

Best

[v-nmadadi-msft]

Hi @BI-Nomad ,

Could you please confirm if you've submitted this as an idea in the Ideas Forum? If so, sharing the link here would be helpful for other community members who may have similar feedback.

If we don’t hear back, we’ll go ahead and close this thread. For any further discussions or questions, please start a new thread in the Microsoft Fabric Community Forum  we’ll be happy to assist.

Thank you for being part of the Microsoft Fabric Community.

[BI-Nomad]

Hi,

I am already aware of the things you mentioned. is this planned to also allow Load times for Paginated Reports when Usage Metrics are not in Review anymore? At the moment there is no good way without 100 Workarounds to get anything near to Monitoring report load times for Paginated Reports. It would be great if this is paid attention to when the Usage matrics are finalized.

Best

[v-nmadadi-msft · Accepted solution]

Hi  @BI-Nomad ,

Please consider posting about the requested feature in the Fabric ideas forum. Microsoft will actively monitor the forum to identify opportunities for implementing new features.
Fabric Ideas - Microsoft Fabric Community

Thanks and Regards

[v-nmadadi-msft]

Hi @BI-Nomad  ,
Thanks for reaching out to the Microsoft fabric community forum.

In some scenarios, you may notice the performance data is missing. This can occur if a user opens a report and interacts with the report before it has completed loading or if an error occurred during the report load also make a note that the Usage Metrics Report semantic model contains usage data for the last 30 days. It can take up to 24 hours for new usage data to be imported. You can't trigger a manual refresh by using the Power BI user interface.

If you suspect data consistency or refresh issues, it might make sense to delete the existing Usage Metrics Report semantic model. Then you can run View Usage Metrics again to generate a new semantic model with its associated usage metrics reports.
Please refer to this document for detailed instructions on how to proceed
Monitor usage metrics in workspaces (preview) - Power BI | Microsoft Learn

If you find this post helpful, please mark it as an "Accept as Solution" and consider giving a KUDOS.
Thanks and Regards