Dataflow Gen2 data does not show up in Lakehouse after publishing - Microsoft Fabric

[newuserxyz]

We have ingested the data into Dataflow Gen2 and published the data into Lakehouse successfully, but could not see any tables present in lakehouse as it shows empty. However, we could see the same data from dataflow gen2 and this is specifically with only one table. Lakehouse shows data on other tables without any issues. please share inputs on this issue.

[newuserxyz]

Thanks for the prompt response @GilbertQ and @aj1973 
The destination for the dataflow gen 2 has been the lakehouse.
And currently the issue has been resolved after a new desination table has been created into lakehouse and pointed to that. However, the issue was with the old lakehouse table where data was shown empty. Are there any issues reported before like this?

[GilbertQ]

Hi @newuserxyz 

Can you please also confirm that you have selected a destination for your data flow Gen 2 which is the lake house?

[aj1973]

Hi @newuserxyz 

You needed to refresh the Dataflow. Please do so.