Forum Discussion

ricetristan's avatar
ricetristan
New Member
8 years ago

On Prem Gateway Cluster - Change Primary

Greetings!   I'm using the On Premises gateway, and have a two-gateway cluster setup and working properly in fail-over mode.   Gateway Cluster - Gateway A (primary) - Gateway B (fail-over secon...
ricetristan's avatar
ricetristan
New Member
8 years ago

Hi Lydia,

 

Thank you for the reply here.  That's roughly what I tried previously (see message above), with the exception that I had done a 'take-over' of Gateway A by Gateway B after removing Gateway B from the cluster (via Remove-OnPremisesDataGateway).  When I had done that, all of my existing reports and dashboards were failing with 'cannot connect to data source'.

 

I guess can re-do this process again and try performing a 'take-over' from both gateways in the cluster, and report back with the status.

 

Thanks,

Tristan

Anonymous's avatar
Anonymous
Not applicable
8 years ago
ricetristan wrote:

Hi Lydia,

 

Thank you for the reply here.  That's roughly what I tried previously (see message above), with the exception that I had done a 'take-over' of Gateway A by Gateway B after removing Gateway B from the cluster (via Remove-OnPremisesDataGateway).  When I had done that, all of my existing reports and dashboards were failing with 'cannot connect to data source'.

 

 

ricetristan,

As my previous reply, after performing the above step, you would also need to do a take-over of gateway B in the machine A.

Regards,
Lydia