Forum Discussion
On Prem Gateway Cluster - Change Primary
ricetristan,
You are able to change Primary gateway. The way to switch primary/secondary is to “Restore” the gateway on the desired machine.
You can reinstall the gateway on the second machine(B) and select “Migrate, restore or takeover an existing gateway” after you signed in in the Configurator, then select the first gateway instance to migrate. Then, you should follow the same steps to migrate the second gateway instance on the first machine(A).
Regards,
Lydia
Hi Lydia,
Thank you for the reply here. That's roughly what I tried previously (see message above), with the exception that I had done a 'take-over' of Gateway A by Gateway B after removing Gateway B from the cluster (via Remove-OnPremisesDataGateway). When I had done that, all of my existing reports and dashboards were failing with 'cannot connect to data source'.
I guess can re-do this process again and try performing a 'take-over' from both gateways in the cluster, and report back with the status.
Thanks,
Tristan
ricetristan wrote:
Hi Lydia,
Thank you for the reply here. That's roughly what I tried previously (see message above), with the exception that I had done a 'take-over' of Gateway A by Gateway B after removing Gateway B from the cluster (via Remove-OnPremisesDataGateway). When I had done that, all of my existing reports and dashboards were failing with 'cannot connect to data source'.
ricetristan,
As my previous reply, after performing the above step, you would also need to do a take-over of gateway B in the machine A.
Regards,
Lydia