Forum Discussion
Dynamic column selection based on slicer selection
When we select nothing it means select all. Is it possible to change when nothing is selected no columns should be displayed in dynamic column selection using slicer
Any work around will be much appriciated from any expert in power BI
I need it badly. 😞
Hi Asmasm
I found some threads but they are for the normal slicer. Not sure if the workarounds of them can be applied to the field parameter. You may have a look first.
Show Blank Data when Nothing is filtered - Microsoft Fabric Community
Visualisations blank until something selected in a... - Microsoft Fabric Community
Best Regards,
Jing
4 Replies
If this is important to you please consider voting for an existing idea or raising a new one at https://ideas.fabric.microsoft.com/?forum=2d80fd4a-16cb-4189-896b-e0dac5e08b41
Any work around will be much appriciated from any expert in power BI
I need it badly. 😞
Hi Asmasm
I found some threads but they are for the normal slicer. Not sure if the workarounds of them can be applied to the field parameter. You may have a look first.
Show Blank Data when Nothing is filtered - Microsoft Fabric Community
Visualisations blank until something selected in a... - Microsoft Fabric Community
Best Regards,
JingStill same issue. Any more ways.
