Forum Discussion
Appending data and applying steps
Hi Community,
I appended one table (Table 2) to my main data table (Table 1), but I cannot seem to figure out how to get the applied steps of Table 1 to apply to the newly appended data. I feel like this is a simple answer, but I have searched and searched and cannot seem to find an answer. I did refresh the tables, and that did not seem to do it. Am I missing something simple here?
Thanks!
Hi mforest ,
Does it work if you move the append step to the top of the list ? So first you append and after it you applied the steps for both tables (once it's appended).
Also, see if you have the Query Steps panel enabled.
2 Replies
Hi mforest ,
Does it work if you move the append step to the top of the list ? So first you append and after it you applied the steps for both tables (once it's appended).
Also, see if you have the Query Steps panel enabled.
I literally JUST found an article that said to do this and it worked! Clearly, I was missing something simple. Thank you!
