cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
mohit_aquila

Slicer converts to single select after publishing

Submitted by on ‎08-29-2022 06:54 AM

I created a report with multiple slicers , all having multiple select options. The report works fine in desktop application. However, when I publish the report, one of the slicer gets converted to single select slicer. How do I resolve this?

Status: Investigating

Could not reproduce it in my side as far as my test, when I have created multiple-selection slicers in a report and publish it to Power BI Service, all of them work fine.

vyingjl_0-1661842467904.png

Desktop version: 2.108.825.0 64-bit (August 2022)

 

Perhaps you can try to republish this report to different workspaces to check it again, if it still has the same issue, you can share more details about it like the desktop version or some screenshots, gif etc.

 

Best Regards,
Community Support Team _ Yingjie Li

 

See more ideas labeled with:
1 Comment (1 New)
Comments
v-yingjl
Community Support
Community Support
‎08-29-2022 11:56 PM
Status changed to: Investigating

Could not reproduce it in my side as far as my test, when I have created multiple-selection slicers in a report and publish it to Power BI Service, all of them work fine.

vyingjl_0-1661842467904.png

Desktop version: 2.108.825.0 64-bit (August 2022)

 

Perhaps you can try to republish this report to different workspaces to check it again, if it still has the same issue, you can share more details about it like the desktop version or some screenshots, gif etc.

 

Best Regards,
Community Support Team _ Yingjie Li

 

Idea Statuses