0

Connect DataflowGen2 to data destination Lakehouse perpetually greyed out

When trying to add a destination to a Dataflow, the connection field is greyed out (regardless of how much time I wait). This means I can't create a new connection or see existing ones. I have previously created Lakehouses in my workspace.

 

The only workaround is to create an on-premises gateway.

 

 

guilhermealexa_0-1700560966458.png

 

Delivered v-xiaoyan-msft (Community Support) responded

Hi @guilhermealexa ,

 

The connection details might not be set up correctly. You can resolve this by selecting “Configure connection” and setting up the connection details and credentials.

 

Also,If your table in the dataflow gets data from an on-premises data source, a gateway is needed for the connection, but the gateway hasn’t been selected. You can resolve this by selecting the gateway. If the gateway hasn’t been set up yet, you’ll need to install an on-premises data gateway. 

 

It's by desgin.

 

Best regards.
Community Support Team_Caitlyn

 

 

 

 

Comments
v-xiaoyan-msft
Community Support
Status changed to: Delivered

Hi @guilhermealexa ,

 

The connection details might not be set up correctly. You can resolve this by selecting “Configure connection” and setting up the connection details and credentials.

 

Also,If your table in the dataflow gets data from an on-premises data source, a gateway is needed for the connection, but the gateway hasn’t been selected. You can resolve this by selecting the gateway. If the gateway hasn’t been set up yet, you’ll need to install an on-premises data gateway. 

 

It's by desgin.

 

Best regards.
Community Support Team_Caitlyn