August 2020 Desktop Update - ESRI map not displaying all information for a data point when selected
I have mapped some data points using the updated ESRI feature and created a table to display information held within my data table for each data point. There are many data points that when selected do not display any information even though data exists within my source table. I am not sure if this is an error in the update or some issue within the data table. You can see that in the map image below I have two data points selected; however, data from only one of them displays.
2 Comments
v-yuta-msftCommunity Support
It's hard to reproduce this issue on my side. Does this issue also occur on the older version?
Regards,
Jimmy Tao
I never attempted this on older versions. Not sure when the ability to search by address was added, but it was key for what I needed the mapping feature for. When I saw (or at least was unable to figure out) how to locate by address, I didn't try to do anything further with my data.
