Forum Discussion
Existing Autodesk Construction Cloud connection not selectable in Dataflow Gen2
With the help of Microsoft support I found out the Autodesk Construction Cloud Connector can NOT be use this way in a Dataflow Gen2.
If you want to use a shared connection it has to be used in a Semantic Model.
It turns out the documentation is not correct on how this connector can be used.
The workaround is as follows.
After creating the connection as described, you have to create a PowerBi Desktop report, and set up a temporarily connection to Autdesk Construction Cloud in that report. Then publsh that report. This creates a semantic model in the workspace where the report is published.In the setting of the Semantic model you can change the connection to the shared connection that was created before in the steps as described above.
Then in the same setting menu enable the option for OneLake ingegration. After a refresh of the semantic model, the semantic model will be available in OneLake.
On top of that you could create a Lakehouse and create a link in the LakeHouse to the semantic model in the Onelake.
Community SupportHi Florisz,
Thanks for sharing the details. Given the nature of the issue, I would recommend raising this directly with Autodesk Support. They’ll be in the best position to assist you further, especially if this involves account-specific settings or licensing concerns.
You can reach Autodesk Support through their official portal here:
Autodesk Community, Autodesk Forums, Autodesk Forum
Thank you.
Thank you for your follow up and link. I did post the same question there🤞.