I'd like to request an optional slicer setting. If the setting is selected, then the slicer will automatically reset to no selection every time you navigate away from the page.
Background
I have two tabs in Power BI. Tab 1 contains a bar chart visual. Tab 2 contains a table of details.
I can drill-through from the bar chart to show the relevant items in the table.
I can then subsequently filter the information in the table, using a slicer.
Problem
If I have used the slicer to filter the table, the next drill-through is affected.
If I navigate back to Tab 1 and drill-through from another category, the filter on Tab 2 persists, and is now stale.
The information shown on Tab 2 is now filtered by a slicer that is out of date.
Solution/Request
If there was an optional setting on the slicers that allowed the slicer to be re-set on navigation, then when the user navigates back to Tab 1 and drills-through to Tab 2, the drill through will be representative of the selected category, and not affected by the stale slicer.
on:
Close, Apply, and Refresh All
miguel
on:
Allow user to modify applied steps in a Dataflow w...
SimplyWilson
on:
Mirroring from Dynamics 365 Business Central into ...