Forum Discussion
Getting Error While Pulling Data from EventHub Via Eventstream into Lakehouse
Hi Anonymous ,
The initial error occurred because the new table in the Lakehouse was still in the process of being created. The subsequent error was likely due to refreshing too frequently. Please wait until the table creation is complete and then refresh again. You should be able to preview the data at that point.
Thanks,
Wenyang
Hi Anonymous ,
Please check that you have met the following prerequisites:
Please refer to the documentations to check that your procedure is not incorrect.
Add Azure Event Hubs source to an eventstream - Microsoft Fabric | Microsoft Learn
Add a lakehouse destination to an eventstream - Microsoft Fabric | Microsoft Learn
If the data preview displays “No data available for preview”, this may be due to data not flowing correctly to the target node.
Check the output of the upstream node to make sure that the data is flowing properly to the target node. Ensure that the target node is configured correctly and that there are no issues with data mapping.
If the target table already exists and the problem persists, try deleting and recreating the target table to ensure that the table structure and configuration are correct.
When recreating the table, ensure that the table name, schema, and fields match the source data exactly.
Best Regards,
Neeko Tang
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.