Forum Discussion

joris's avatar
joris
Frequent Visitor
7 years ago
Solved

unable to setup incremental refresh

I've tried to setup an incremental refresh but keep getting stuck at the same point. So far I have:   -created date/time parameters "RangeStart" and "RangeEnd" -applied a custom filter to a date/t...
Need Help
  • arvindsingh802's avatar
    arvindsingh802
    7 years ago

    Finally got slution after lot of efforts
    We have to keep the Parameter name as RangeStart and RangeEnd only.
    You can not use any other name for incremental refresh paramenters.

v-piga-msft's avatar
v-piga-msft
Resident Rockstar
7 years ago

Hi joris,

 

How do you set the parameter?

 

The RangeStart and RangeEnd parameters should be datefield date/time, not just Date. 

 

You could note here.

 

 

In addition, you could have a reference of this similar thread which has been solved.

 

Best  Regards,

Cherry

  • arvindsingh802's avatar
    arvindsingh802
    Community Champion
    7 years ago

    v-piga-msft, I have my Parameters as Date/time and the column also as Date/Time
    but still getting same error as before you can set up incremental refresh on this table you need to set up parameters site:community.powerbi.com

    Custom is working fine but not able to setup the incremental load.

    • arvindsingh802's avatar
      arvindsingh802
      Community Champion
      7 years ago

      Finally got slution after lot of efforts
      We have to keep the Parameter name as RangeStart and RangeEnd only.
      You can not use any other name for incremental refresh paramenters.