Forum Discussion

wotkara's avatar
wotkara
Frequent Visitor
2 years ago

model view relationships

Good evening, I am new to this but trying to learn. This Community has been super helpful to me. Here is my model view. When I use "Office Location Lookup - Office Code" to slice the page, it will fi...
Need Help
Anonymous's avatar
Anonymous
Not applicable
2 years ago

Hi wotkara ,

Please try below steps:

1. Check Relationship Configuration: Ensure that there is an active relationship between the "Office Location Lookup" table and the "Inventory Lookup" table. The relationship should be correctly defined with appropriate cardinality and cross-filter direction.

 

2. Verify Slicer Configuration: Make sure the slicer is correctly set up to filter through the related tables. If the slicer is based on a column from the "Office Location Lookup" table, it should ideally filter any table that is directly or indirectly related to it, assuming the relationships are correctly set up.

 

3. Review Relationship Behavior: Understand that slicers work by applying filters through relationships. If the relationship between "Office Location Lookup" and "Inventory Lookup" is not active or is set as inactive due to multiple relationships, it might not filter as expected.

 

Best regards,
Community Support Team_Binbin Yu
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.

wotkara's avatar
wotkara
Frequent Visitor
2 years ago

I have followed the steps above and cannot get the table to filter by location. I have my page setup for the slicer to interact with all tables. I have tried changing the relationships many different ways. Any tips on how to I can work thru the model to get how I want it? I've tried deleting all relationships and adding 1 by 1 back on to see where it breaks. I've tried filtering both ways, filtering one way, changing from one to many and many to many. I cannot figure out how to relate the tables.