Forum Discussion

4 Replies

  • v-qiuyu-msft's avatar
    v-qiuyu-msft
    Community Support
    7 years ago

    Hi JAVED,

     

    You can create a measure below: 

    Measure = SUM(Table1[A])& "," & SUM(Table1[B])&"," & SUM(Table1[C]) &"," &  sum(Table1[D])

     

     

    Best Regards,
    Qiuyun Yu 

  • Anonymous's avatar
    Anonymous
    Not applicable
    7 years ago

    As you've stated you need Count in your measure, substitute v-qiuyu-msft's solution with Count

     

    Measure = SUM(Table1[A])& "," & COUNT(Table1[B])&"," & COUNT(Table1[C]) &"," &  COUNT(Table1[D])

    • JAVED's avatar
      JAVED
      Helper I
      7 years ago

      But i have filters with A,B,C,D the output have to display only that value when i click on filters For example if i click on A it should display only A value

      • Anonymous's avatar
        Anonymous
        Not applicable
        7 years ago

        Sounds like you need to unpivot the A,B,C & D columns in the table in Power Query and that will give you a single column for the values of A,B,C & D and also another column that attributes A,B,C or D to the value.

         

        You would then be looking at a formula like this:

        Measure = CALCULATE(SUM(Table1[Values], Table1[Attributes] = "A")) &","& CALCULATE(COUNT(Table1[Values], Table1[Attributes] = "B")) &","& CALCULATE(COUNT(Table1[Values], Table1[Attributes] = "C")) &","& CALCULATE(COUNT(Table1[Values], Table1[Attributes] = "D")