While doing a cross report drill Slicer value is not getting filtered in target report properly.

[soumikdas6]

I have two report:
Source report, where based on "tenant" I am doing the cross drill, and in target report I am seeing the cross report drill detail info.
In default it's working fine, but in source report I have a relative date slicer and the same slicer is also present in Target table, so whenever I am selecting a specific value in source table slicer and doing a cross drill. Same slicer value is not getting filtered in Target report.
Ex : By default in source and target report date slicer is having value of "30 days". If i select a value in source slicer "Last month" and then doing the cross report drill on target report, then target report is going blank. Slicer is not picking up the value "Last month" automatically. Any suggestion on this?

[soumikdas6]

It's already enabled, still the slicer is not getting auto filtered.

[lbendlin]

Please confirm that "Keep all filters" is enabled  in the drill destination page