Tachometer gauge not showing correct position

Hi v-eachen-msft  what you have shown would be exactly what I'm after however it seems to me as if setting min/max values only allows a text input rather than dragging in a measure?  My issue is that I have many gauges used in drillthrough pages so the max value will always differ.  I also want the gauge to still show going into the red if over a target value.  Hope that makes sense!

Would you be able to advise in more detail, perhaps a screenshot of showing the settings you have used to achieve what you have shown?

Based on your comments and after some twiddling I've managed to achieve what I needed.

1) Created a measure, StartValue = 0 and set this as the Start Value
2) Created individual measures for each gauge as the target * 1.1 and set this as the End Value

3) Target value set to the relevant target value

4) Range3 start value set to the target value

Probably an easier way of doing it than having to create inidivual measures for every gauge end value (I have about 25 on the report) but the above seems to work for me