Forum Discussion

Shakeerm's avatar
Shakeerm
Helper II
6 years ago
Solved

Percentage Labels into a Line & Stacked Column Chart

Hi 

I have a Line & Stacked Column Chart that illustrates the Ontime/Overdue jobs for each Job Branch

I need to show the Percentage of 100% for each Branch. 

 

When i tried to Show Value as Percent of grand total it shows the Branch Percentage for all the Branches. 

 

 

This is the Column that i have added to formulate Ontime/Overdue

 

 

Tried a few DAX functions and none of them gave a the right results. 

Appreciate the Help

Need Help
  • sanimesa's avatar
    sanimesa
    6 years ago

    Shakeerm  You may need to create a few measures for this. Here is a sample worked out - please create measures like this:

     

     

    Total Count = COUNTROWS(OnTime)
OnTime Count = CALCULATE([Total Count], OnTime[Status]="ONTIME")
Overdue Count = CALCULATE([Total Count], OnTime[Status]="OVERDUE")
% OnTime = DIVIDE(OnTime[OnTime Count], [Total Count])
% Overdue = DIVIDE([Overdue Count], [Total Count])

     

     

    Then set up the chart as shown in the picture below.

3 Replies

  • sanimesa's avatar
    sanimesa
    Post Prodigy
    6 years ago

    Shakeerm  You may need to create a few measures for this. Here is a sample worked out - please create measures like this:

     

     

    Total Count = COUNTROWS(OnTime)
OnTime Count = CALCULATE([Total Count], OnTime[Status]="ONTIME")
Overdue Count = CALCULATE([Total Count], OnTime[Status]="OVERDUE")
% OnTime = DIVIDE(OnTime[OnTime Count], [Total Count])
% Overdue = DIVIDE([Overdue Count], [Total Count])

     

     

    Then set up the chart as shown in the picture below.

  • Anonymous's avatar
    Anonymous
    Not applicable
    6 years ago

    Try this measure:

     

    Pencentage Values = COUNTA(Table[Overdue]) / CALCULATE(COUNTA(Table[Overdue]),ALL(Table[Overdue]))

     

    Change the data type to pecentages and you should be good to go. It's going to mess with your axis though.

  • v-lili6-msft's avatar
    v-lili6-msft
    Community Support
    6 years ago

    HI  Shakeerm 

    Just create a measure as below:

    Measure =
DIVIDE (
    CALCULATE ( COUNTA ( 'HR Performance Analysis Report'[Job No] ) ),
    CALCULATE (
        COUNTA ( 'HR Performance Analysis Report'[Job No] ),
        ALLSELECTED ( 'HR Performance Analysis Report'[Overdue] )
    )
)

     

    Then drag this measure into Column values of the visual.

     

    Regards,

    Lin