Forum Discussion
Passing Measure output in MQuery
v-dineshya Thanks for checking. We have done it in other way. I will share it once it is done.
Right now it is required we can close this.
HI Anonymous ,
Thank you for reaching out to the Microsoft Fabric Community forum.
In Power BI, you cannot directly pass a DAX measure value into an M query, because M queries run before DAX measures are evaluated. This is due to the Power BI data refresh and modeling architecture, Power Query is responsible for data load and transformation, while DAX is evaluated after the data is loaded.
Note: You Cannot Use DAX Measures in M because, M queries run at data load time. DAX measures run at report interaction time. There is no direct runtime bridge between DAX measures and M parameters.
Please refer Community thread.
Solved: Use Measure in Mquery - Microsoft Fabric Community
If this information is helpful, please “Accept it as a solution” and give a "kudos" to assist other community members in resolving similar issues more efficiently.
Thank you.
Hi Anonymous ,
We haven’t heard from you on the last response and was just checking back to see if you have a resolution yet.do click Accept Answer and Yes for was this answer helpful. And, if you have any further query do let us know.
Thank you.
Hi @pbiforum_123 ,
We haven’t heard from you on the last response and was just checking back to see if you have a resolution yet.do click Accept Answer and Yes for was this answer helpful. And, if you have any further query do let us know.
Thank you.
Hi @pbiforum_123 ,
We haven’t heard from you on the last response and was just checking back to see if you have a resolution yet.do click Accept Answer and Yes for was this answer helpful. And, if you have any further query do let us know.
Thank you.