Forum Discussion
Parameter Slicer shows incorrect value
Hello everybody!
Im haveing a problem with a parameterbased slicer.
The parameter looks like this: Parameter =
Hi Zynka
I can reproduce your problem, as searched, it is said "it's because of the range being too big and the numbers are being sampled" accoding to the following link.
What if parameter help - input changes by itself after hitting enter
As a workround, you could click on the "down" arrow on the top-right of slicer and select "between" or "list" as below
or you could change the "increment" from 1 to 5 as my first picture.
Best Regards
Maggie
Community Support Team _ Maggie Li
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.
5 Replies
Hi Zynka
I can reproduce your problem, as searched, it is said "it's because of the range being too big and the numbers are being sampled" accoding to the following link.
What if parameter help - input changes by itself after hitting enter
As a workround, you could click on the "down" arrow on the top-right of slicer and select "between" or "list" as below
or you could change the "increment" from 1 to 5 as my first picture.
Best Regards
Maggie
Community Support Team _ Maggie Li
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.maybe its because of the minimal autogenerated value is 3, not 0 or 1?
Thanks for your answer, dont know if I understand correctly but I can still get the value 0 or 10 000 both by typing or move the controller. It appers like it somewhere above 1 500 begins to count 3, 8, 13, 18 etc.
Hi Zynka
As tested with last version 2.66.5376.1681 64-bit (February 2019), it works correctly on my side.
Could you show an screenshot or an simple pbix how you create and use the parameter?
Best Regards
Maggie
Hi!
Ofcourse, Im having the same problem with several slicers
The value I try to put in is 2575 but its autocorrecting to 2577, as you can see this is a new project so it dosnt depend on my actuall report, maybe som settings I dont know off?
Thankfull for your time//
Jesper @ Zynka
