Forum Discussion

Krcmajster's avatar
Krcmajster
Helper IV
7 years ago

Paramaters changing

Hi,    So I have a measure that I need to generates series: Rent Par. = GENERATESERIES(0, 10000, 1) I am using it with the slider and entry box. And it works how it should when I drag the slid...
Need Help
Krcmajster's avatar
Krcmajster
Helper IV
7 years ago

Unfortunatley I can't share the file as it contains confidential information. 

I have the latest version. It works when I use the slider like you did it, however, when I type in the box the number I get the previous problem. I don't want to use the slider, I just need this free entry box where I can put whatever number I need.

 

It works with smaller spans (0-500), but not with higher one (0-5,000, or like in my case 0-10,000)

v-frfei-msft's avatar
v-frfei-msft
Community Support
7 years ago

Hi Krcmajster ,

 

I didn't use the slider here, just entering the number in the box and no issue was found again. What kind of visual did you use here? Did you use the Slicer as I tested?

 

Regards,

Frank

  • Krcmajster's avatar
    Krcmajster
    Helper IV
    7 years ago

    v-frfei-msft I create it with "what if" New Parameter. I have tried the same on on my coworkers laptop and it's the same.

    See below. I create it , I want to enter in this example 3567 and when I hit enter I get 3566.

    2341 goes to 2428, 1534 goes to 1583 and so on

    q