Not able to Click Power Automate Button in PowerBi APP

[JesusCut]

Good morning,

I have a PowerAutomate button in a PowerBi report where I enter different information through measurements. In the Desktop it works without any problem but after publishing it on the web, I can't click the button. The button is not executed. I click on the button but I can't get it to execute anything. It is as if it remained selected. It has never happened to me before. I have the feeling that it is because it has too much information although I really don't think so.

Do you know what could be happening?
Do you know if there is some limit of weight for the measures that go in this button?
Any alternative?

Thank you in advanced

[JesusCut · Accepted solution]

It seems that the problem came from "internet explorer". Refreshing the page solved the problems. It may be a Caché problem. I have opted to load a previous update and redesign the report. It seems to be working correctly now.

Thank you.

[JesusCut]

Thank you for your response.

Yes, I have checked but the flow does not get to run. The button has several measures but no tables. 

Before the button was working fine but now when entering some more measures in the button it doesn't execute. I click on the button but it does not start executing.

I will check if any of the measures can be causing this. Or if perhaps the measures cause a higher weight inside the button.

[christinepayton]

If it's not triggering at all, I would try removing and re-hooking up the button. It should at least be triggering when you click it, whether or not it has issues with any part of the rest of it. 

[christinepayton]

Did you look at the flow history? That should tell you what's going on with it - it's probably triggering, but there is no indication from the PBI side of whether or not the flow run was successful, you have to go in and look at it at make.powerautomate.com to get more info or an error message. 

IIRC the limit is something like 1million rows x columns, but if it's over that it'll still run, it'll just only receive that many rows.