Multiple slicers make graph go blank

[Anonymous]

I am attempting to make a dynamic line graph to visual labor demand vs a static labor capacity line for my company. There is a table for each product line at our facility with three production volume scenarios. I have created a measure for each product line to switch between each of these scenarios. 

DM Hours =

VAR DM = SELECTEDVALUE(Scenario[DM Scenario])

Return

Switch(true(),

DM="PP",SUM('DM'[PP Hours]),

DM="S1",SUM('DM'[S1 Hours]),

DM="S2",SUM('DM'[S2 Hours]))

There are six product lines in total. I have created a scenario column for each of them for the three possible scenarios "PP", "S1", and "S2". My intention was to have a slicer that would be able to change the values for a product line in each scenario.

There would be seven lines in the graph. One for each product line, and then a total. I created another measure to sum each of product line measures.(see the measure above). The problem I'm having is, if all of the slicers are not set to the same selection, the graph goes blank. I have turned off the interaction between the slicers, but this did not help. Any advice would be greatly appreciated. 

[v-kelly-msft]

Hi  @Anonymous ,

Is your issue solved now?If not,could you pls check my last reply?

Best Regards,
Kelly

Did I answer your question? Mark my post as a solution!

[Anonymous]

First picture with matching slicer selections. Second picture with non-matching slicer selections. Each slicer is using a different column, so it not as if I am trying to select two scenarios from the same column at once.

[v-kelly-msft]

Hi  @Anonymous ,

It means that the selections conflict.Could you pls provide some sample data with expected output for test?

Remember to remove the confidential information.

Best Regards,
Kelly

Did I answer your question? Mark my post as a solution!