Forum Discussion
List Slicer not rendering in Service
After fiddling around with the format settings in the PBI Service, I found a workaround.
Under Layout, I unchecked fixed number of buttons, and set the Max buttons shown to 2.
After republishing, the List Slicer is now rendering properly.
I am a little unsettled, however, that it stopped rendering properly with Fixed Number of Buttons set to Yes. But, I will mark this as a solution anyway.
After fiddling around with the format settings in the PBI Service, I found a workaround.
Under Layout, I unchecked fixed number of buttons, and set the Max buttons shown to 2.
After republishing, the List Slicer is now rendering properly.
I am a little unsettled, however, that it stopped rendering properly with Fixed Number of Buttons set to Yes. But, I will mark this as a solution anyway.
I also had the same problem with rendering.
Starting from the proposed solution and because I didn't want to do any change in layout, I've found that just doing the following steps, it fix the problem:
1. Have a look at the configuration you made of "Button shown" (3 in my case).
2. Uncheck "Fixed number of buttons" --> this will probably reset also the number of "Button shown" to default (8).
3. If chanceg, set "Button shown" with the desired number (3 in my case).
4. Check "Fixed number of buttons"
--> Now you have the same settings as before
5. Save and publish the report and the list slicer will now render correctly. 🙂
Hope this additional information it'll be useful to others.