I want to send alert from the forecast upper bond and lower bond data. how should i do it?

[Anonymous]

I'm using line graph and doing forecast based on the data I have. I want to send an email alert when my forecast data (upper bound or lower bound) falls out of the limit that I set. when I put my curson on the forecast graph I can see the lower bound and upper bound data. but how do I get those datas and use that to send alert?

[amitchandak]

Refer, if this can help:https://docs.microsoft.com/en-us/power-bi/service-set-data-alerts

[Anonymous]

Thanks for your reply. I can send the alerst now. But i want to know how to get the upper bound data and lower bound data on the card / tile. I want to send alret if my upper bond and lower bound data while doind forecasting

[v-easonf-msft]

Hi, @Anonymous 

It is necessary  to create  another measures  to calculate the  current values of  upper bound data and lower bound data.

Then put the measures  into  the below visuals (only on gauges, KPIs, and cards). 

After you  publish the report  to service and   pin  the  visual (only on gauges, KPIs, and cards)  to a dashboard ,you can manage your alert  and set the excepted   trigger boundary.

Best Regards,
Community Support Team _ Eason

[Anonymous]

Thanks for the reply Community Support Team _ Eason,

How do I get the current value of upper bound lower bound value? how to get those values on card?

Thanks,

Mubariz

[v-easonf-msft]

Hi ,  @Anonymous 

Sorry I can't solve this problem .

If we want to find  out the lower bound value ( the point in the figure), we must understand the calculation logic of the forecast part. However I know nothing about this.

In addition, I will try to find someone who is familiar with this to take a further look at this. I will post back if we have any conclusions on this topic.

Best Regards,
Community Support Team _ Eason

[Anonymous]

@v-easonf-msft @amitchandak  its ok if we cannot extract those data. is it possible to have the calculation that used to forecast the data and we do it seprately in another table?

[v-easonf-msft]

Hi , @Anonymous 

Sorry for that I can't solve your problem.

I suggest you create a support ticket to investigate the issue for better answer. Once you create a support ticket, please share the same here for reference.
https://powerbi.microsoft.com/en-us/support/

Best Regards,
Community Support Team _ Eason

[Anonymous]

Thanks @v-easonf-msft . I hope you can find someone to help on this.